Maytag MMMF8030PZ Owners Manual - Page 21

7. Return the damper plate to its original horizontal position. A Install Damper Assembly for Roof Venting Installation 1. Check that damper blade moves freely and opens fully. 2. Insert damper assembly through the cabinet cutout so that the long tab of the damper assembly slides under the raised tabs of the damper plate. Then secure with #6 x 3/8" sheet metal screw. NOTE: The screw cannot be installed if the damper assembly is not positioned as shown. A B C A. Damper plate 8. Secure damper plate with screw removed in Step 1. A B A. Damper plate B. Screw 9. Repeat Step 14 from "Wall Venting Installation Only." Install Damper Assembly If for recirculation installation, no need to install the damper assembly, this section can be skip. And save it for future use. Install Damper Assembly for Wall Venting Installation 1. Check that damper blade moves freely and opens fully. 2. Position the damper assembly on the back of the microwave oven so that the damper blade hinge is at the top, and the damper blade opens away from the microwave oven. A B C D D E F A. Raised tabs B. Damper assembly C. #6 x 3/8" Sheet metal screws D. Upper cabinet cutout E. Long tab F. Damper plate 3. Connect vent to damper assembly. A B A. Vent B. Damper assembly (under vent) A. Back of microwave oven B. Damper assembly C. Damper blade D. #6 x 3/8" Sheet metal screws 3. Secure damper assembly with two #6 x 3/8" sheet metal screws. 21