Metabo PE 15-20 RT Operating Instructions - Page 15

the machine does not start up. Switch the machine off and back on again. 11. Accessories Use only genuine Metabo accessories. Use only accessories that fulfil the requirements and specifications listed in these operating instructions. See page 4. A Hook and loop backing pad (for attaching polishing and sanding accessories) B Hook and loop polishing pad, coarse (for buffing weathered paint) C Hook and loop polishing pad, fine (for polishing paint) D Hook and loop polishing felt, soft (for buffing paint,ferrous metals and stainless steel sheets) E Hook and loop lambswool polishing disc (for buffing weathered paint) F Cushioning disc with Velcro fasteners (for sanding curved surfaces) G Felt polishing disc with internal thread M 14 H Plastic disc brushes For a complete range of accessories, see www.metabo.com or the catalogue. 12. Repairs Repairs to electrical tools must ONLY be carried out by qualified electricians! A defective mains cable must be replaced only with a special, original mains cable from metabo available from the Metabo service. Contact your local Metabo representative if you have Metabo power tools requiring repairs. See www.metabo.com for addresses. You can download a list of spare parts from www.metabo.com. 13. Environmental Protection Observe the national regulations on environmentally compatible disposal and on the recycling of disused tools, packaging and accessories. Only for EU countries: never dispose of power tools in your household waste! Used power tools must be collected separately and handed in for environmentally compatible recycling in accordance with European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in national legal systems. ENGLISH en l = Length of the sanding spindle n* = No-load speed (maximum speed) nS = No-load speed depending on the thumbwheel position nPmPN12* = Speed at rated load = Rated input power = Power output = Weight without mains cable Measured values determined in conformity with EN 60745. Machine in protection class II ~ AC power * Energy-rich, high-frequency interference can cause fluctuations in speed. The fluctuations disappear, however, as soon as the interference fades away. The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. The actual load may be higher or lower depending on the operating conditions, the condition of the power tool or the accessories. Please allow for breaks and periods when the load is lower for assessment purposes. Arrange protective measures for the user, such as organisational measures based on the adjusted estimates. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: aahh,, P DS =Vibration emission value (polishing) =Vibration emission value (sanding surfaces) Kh,P/Kh,DS =Uncertainty (vibration) Typical A-effective perceived sound levels: LKLpWpaAA, = Sound-pressure level = Acoustic power level KWA= Uncertainty The noise level can exceed 80 dB(A) during operation. Wear ear protectors! 14. Technical Specifications Explanatory notes on the specifications on page 3. Subject to change in accordance with technical progress. MMDmt, amxax = maximum support plate diameter = maximum torque = Spindle thread 15