Miele Boost CX1 Operating instructions/Installation instructions - Page 16
Adjustable floorhead Fig. 18
View all Miele Boost CX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
en-US Press the foot switch . If the suction power of the adjustable floorhead seems too high, reduce the suction until the floorhead is easier to maneuver (see "Use" - "Regulating the suction power"). Adjustable floorhead (Fig. 18) The adjustable floorhead can also be used for vacuuming the stairs. Risk of injury caused by falling vacuum cleaner. You may be injured if the vacuum cleaner should fall from the stairs. When vacuuming stairs, it is best to start at the bottom of the stairs and move up. Power cord Unwind the cord completely to aid the vacuum in dissipating heat. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord. Keep the cord away from heated surfaces. Do not unplug by pulling the cord. To unplug grasp the plug, not the cord. This appliance is equipped with a power cord reel. Hold the plug when rewinding onto cord reel. Do not allow plug to whip when rewinding. Unwinding the power cord (Fig. 19) Pull the power cord out to the required length. Insert the plug into the electrical socket. 16 Risk of damage due to overheat- ing. The power cord may overheat after a long period of use. If vacuuming for longer than 30 minutes, the power cord must be pulled out all the way. Rewinding the power cord (Fig. 20) Remove the plug from the electrical socket. Press the rewind foot switch. The power cord will rewind automatically. Switching on and off (Fig. 21) Press the On/Off foot switch . During vacuuming During vacuuming, pull the vacuum cleaner behind you like a sledge. Selecting the suction power The suction power can be adjusted to suit the type of flooring being cleaned. Reducing the power lowers the amount of effort required to maneuver the floor brush. The vacuum cleaner has symbols on the controls which indicate the type of use the settings are suitable for. Curtains, lightweight fabric Deep pile carpets, rugs and runners Low pile carpet and rugs Hard flooring and heavily soiled carpets and rugs (also for cleaning upholstery and mattresses with the upholstery nozzle)