NEC LT170 LT170 user's manual - Page 22

PROJECTING AN IMAGE (BASIC OPERATION) Turning off the Projector To turn off the projector: First, press the POWER (ON/STAND BY) button on the projector cabinet or the POWER OFF button on the remote control. The "Power Off / Are you sure?" message will appear. MENU LAMP STATUS POWER ON/STAND BY SELECT SOURCE ENTER OFF P0WER ON VIDEO S-VIDEO COMPUTER COMP. AUTO ADJ. AUTO ASPECT ENTER MENU CANCEL Secondly, press the ENTER button or press the POWER (ON/STAND BY) or the POWER OFF button again. The power indicator will glow orange. After the projector turns off, the cooling fans keep operating for 60 seconds (Cooling-off time). Lastly unplug the power cable. The power indicator will go out. CAUTION Do not unplug the power cable from the wall outlet under any one of the following circumstances. Doing so can cause damage to the projector: • While the Hour Glass icon appears. • While the cooling fans are running. (The cooling fans continue to work for 60 seconds after the projector is turned off). After Use Preparation: Make sure that the projector is not turned on. 1. Unplug the power cable. 2. Disconnect any other cables. 3. Retract adjustable tilt feet if extended. POWESRTATLUASMP ON/STAND BY ENTSEORURCE SELECT FOCUS 2 1 3 CLOSE PUSH ZOOM MENU AUDIO IN S-VIDEO IN VIDEO IN COMPUTE ᕃ Lift the front part of the projector. ᕄ Push and hold the PUSH symbol of the Adjustable Tilt Foot button to extend the adjustable tilt feet up to a maximum height. ᕅ Lower the front of the projector while pressing and holding the Adjustable Tilt Foot button until retracting the Adjustable Tilt Foot down to a minimum height. 4. Use the Lens Shutter lever to close the lens shutter. ENTSEORURCE SELECT MENU PUSH ZOOM FOCUS VI AUDIO IN S-VIDEO IN 5. Put the projector and its accessories in the soft carrying case. See "Using the Soft Carrying Case" on the following page. E-22