Netgear DG834GUv5 Reference Manual - Page 117
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G
View all Netgear DG834GUv5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
DG834G Reference Manual • "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G" on page -7 uses the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway. • "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page -12 configures the NETGEAR ProSafe VPN Client endpoint. Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 8-2 on page 8-5. If you have special requirements not covered by these VPNC-recommended parameters, refer to "How to Set Up VPN Tunnels in Special Circumstances" on page 8-35 to set up the VPN tunnel. The worksheet below identifies the parameters used in the following procedure. A blank worksheet is at "Planning a VPN" on page 8-3. Virtual Private Networking 8-7 v3.0, September 2005