Netgear DG834GUv5 Reference Manual - Page 136
Click on VPN Status - as repeater
View all Netgear DG834GUv5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
DG834G Reference Manual 6. Repeat for the DG834G on LAN B and pay special attention to use the following network settings as appropriate. • WAN IP of the remote VPN gateway (e.g., 14.15.16.17) • LAN IP settings of the remote VPN gateway: - IP Address (e.g, 192.168.0.1) - Subnet Mask (e.g., 255.255.255.0) - Preshared Key (e.g., 12345678) 7. Use the VPN Status screen to activate the VPN tunnel by performing the following steps: Note: The VPN Status screen is only one of three ways to active a VPN tunnel. See "Activating a VPN Tunnel" on page -27 for information on the other ways. a. Open the DG834G management interface and click on VPN Status to get the VPN Status/ Log screen (Figure 8-27). Figure 8-27: VPN Status/Log Screen b. Click on VPN Status (Figure 8-29) to get the Current VPN Tunnels (SAs) screen (Figure 8-28). Click on Connect for the VPN tunnel you want to activate. 8-26 v3.0, September 2005 Virtual Private Networking