Netgear R8000 User Manual - Page 11
Rear Panel, LED On/Off, Reset - power light blinking
View all Netgear R8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Nighthawk X6 AC3200 Tri-Band WiFi Router Table 1. LED and button descriptions (continued) LED USB 3.0 port USB 2.0 port Ethernet ports 1-4 Description The USB 1 LED is for the USB 3.0 USB port on the front panel. The USB 2 LED is for the USB 2.0 port on the rear panel. • Solid white. A USB device is connected and is ready. • Blinking. A USB device is plugged in and is trying to connect. • Off. No USB device is connected or someone clicked the Safely Remove Hardware button, and it is now safe to remove the attached USB device. The LED color indicates the speed: white for Gigabit Ethernet connections and amber for 100 Mbps or 10 Mbps Ethernet connections. • Solid. A powered-on device is connected to the Ethernet port. • Blinking. The port is sending or receiving traffic. • Off. No device is connected to this Ethernet port. WiFi On/Off Pressing this button for two seconds turns the 2.4 GHz and 5 GHz WiFi radios on and off. button with LED If this LED is lit, the WiFi radios are on. If this LED is off, the WiFi radios are turned off and you cannot use WiFi to connect to the router. WPS button with This button lets you use WPS to join the WiFi network without typing the WiFi password. The LED WPS LED blinks white during this process and then lights solid white. You can use the LED On/Off switch on the rear panel of the router to turn the LEDs on the top of the router on or off. See Turn the LEDs On or Off on page 12. Rear Panel The rear panel connections and buttons are shown in the following figure. USB 2.0 LED On/Off Ethernet Internet USB 3.0 Reset Power Power port switch LAN ports 1-4 port port button connector On/Off Figure 3. Router rear panel Pressing the Reset button restores the factory settings. See Factory Settings on page 166. Hardware Setup 11