Netgear XSM7224S XSM7224S Hardware Installation Guide - Page 6
Left side LED, Table 1., LED Descriptions for XSM7224S - 10g switch
UPC - 606449073706
View all Netgear XSM7224S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Managed Stackable Switch XSM7224S l Table 1. LED Descriptions for XSM7224S LED ID Stack Master Power Fan 10GBT Ports (2 LEDs per port) Description This is the stack member ID (1-99) that the software assigns to the switch. • Green: The switch acts as a master unit in a stack of XSM7224S series switches. • Off: The switch acts as a slave unit in a stack of XSM7224S series switches. • Solid green: The power module is present, is supplying power to the switch, and is working normally. • Solid yellow: The system is in boot-up stage. • Blinking yellow: Power module is present but has failed. • Off: Power is disconnected. • Solid green: The fan is operating normally. • Solid yellow: The fan has failed. • Off: No fan is detected. Right side LED 10/100M Link/ACT LED: • Off: No 10/100M link is established on the port. • Solid yellow: A valid 10/100M link is established on the port. • Blinking yellow: The port is transmitting or receiving packets at 10/100Mbps. SFP+ Ports (1 SPD/Link/ACT LED per port) Left side LED 1G/10G Link/ACT LED: • Off: No 1G/10G link is established on the port. • Solid Green - A valid 10Gbps link is established on the port. • Blinking Green - Packet transmission or reception is occurring on the port at 10Gbps. • Solid Yellow - A valid 1000Mbps link is established on the port. • Blinking Yellow - Packet transmission or reception is occurring on the port at 1000Mbps. Note: If port 21-24 media is changed to SFP+, the RJ-45 LEDs change to OFF status. • Off: No SFP/SFP+ module link is established on the port. • Solid green: A valid 10Gbps SFP+ module link is established on the port. • Blinking green: The port is transmitting or receiving packets at 10Gbps. • Solid yellow: A valid 1Gbps SFP module link is established on the port. • Blinking yellow: Packet transmission or reception is occurring on the port at 1Gbps. Note: If port 21-24 media is changed to copper, the SFP+ LEDs change to Off status. 6 | Chapter 1. Introduction