NordicTrack E8200 Competition Bench Uk Manual - Page 12

18. Slide a Weight Bar Adapter (22) onto the Weight Bar (18). Then, tighten a Weight Bar End Knob 18 (44) into the Weight Bar. Attach the other Weight Bar Adapter (not shown) in the same way. 18 22 19. Remove the Lower Cable Eyelet (10), the M8 Nut (99), and the Cable Stop (103) from the Low Cable (52). Route the Cable through the Foot Plate (28). Attach the Foot Plate (28) to the Center Upright (3) with two M12 x 70mm Patch Bolts (89) and two M12 Washers (93). Slide the Cable Stop (103) onto the Low Cable (52), and tighten the M8 Nut (99) onto the Cable as far as possible. Next, tighten the Lower Cable Eyelet (10) onto the Cable as far as possible, and tighten the Nut against the Lower Cable Eyelet. Then, slide the Cable Stop onto the Lower Cable Eyelet. 19 89 93 3 28 103 10 52 99 44 89 93 20. Orient a Barbell Rest (30) as shown, and insert the pin on the Barbell Rest into a slot in the Right Upright (2). Then, rotate the Barbell Rest to the position shown in the inset drawing and slide it downward as far as possible. Attach a Barbell Spotter (29) below the Barbell Rest (30) in the same way. Then, attach the other Barbell Rest (30) and the other Barbell Spotter (29) to the Left Upright (1). 20 Pin 30 2 29 30 30 1 29 12