Oki LE850DT LE840/LE850 Users Guide - Page 65
Position and PrintTone FineAdjustment, 2.9.1 Fine Adjustment
![]() |
View all Oki LE850DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
2. PRINTER SETUP 2.9 Position and Print Tone Fine Adjustment 2.9 Position and Print Tone Fine Adjustment This section describes how to fine adjust a print start position, cut/strip position, reverse feed amount, print tone, and ribbon motor torque. When a fine adjustment is required, follow the procedure below. Power OFF Power ON ONLINE Mode [PAUSE] PAUSE state Hold down [RESTART] User System Mode Hold down [MODE] • Reset • Parameter setting (⇒Section 2.6.2) • Fine adjustment (⇒Section 2.9) • LAN/WLAN (⇒Section 2.6.3) • BASIC (⇒Section 2.6.4) • Z-MODE (⇒Section 2.6.5) • AUTO calibration (⇒Section 2.6.6) • Dump mode (⇒Section 2.6.7) • Log (⇒Section 2.6.8) 2.9.1 Fine Adjustment USER SYSTEM MODE RESET PARAMETER SET ADJUST SET LAN/WLAN Contents of the Fine Adjustment Menu Menu Adjust set Parameter FEED ADJ. CUT ADJ. BACK ADJ. X ADJUST TONE ADJ. (TRANS.) TONE ADJ. (DIRECT) RBN ADJ. RBN ADJ. THRESHOLD THRESHOLD Adjusts the feed amount to the print start position Adjusts the cut or strip position. Adjusts the reverse feed amount. Adjusts the print position in X coordinate (horizontal direction) Adjusts the print tone for thermal transfer printing. Adjusts the print tone for direct thermal printing. Adjusts the ribbon take-up motor drive voltage. Adjusts the ribbon feed motor drive voltage. Sets a fine adjustment value for the threshold for the reflective sensor (Black mark sensor). Sets a fine adjustment value for the threshold for the transmissive sensor (Gap sensor). NOTE: The printer driver's properties screen also has Parameter Fine Adjustment menu. E2-51
![](/manual_guide/products/oki-data-le840dt-le840le850-users-guide-9c1dfd7/65.png)