Onkyo HT-R570 Owner Manual - Page 20
Connecting Speaker Set A, 2-5/812-15mm, 8-1/210-12mm, Speaker Set - surround settings
View all Onkyo HT-R570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Connecting the AV receiver-Continued Connecting Speaker Set A 1 Strip 1/2"-5/8" (12-15 1/2"-5/8"(12-15mm) mm) of insulation from the ends of the speaker cables. (Supplied speaker cables are already stripped.) 2 Unscrew the terminal. Fully insert the bare wire, making sure that it's touching the threaded shaft in the center. Screw the terminal tight. Connecting Speaker Set B 1 Strip 3/8"-1/2" (10-12 3/8"-1/2"(10-12mm) mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 2 While pressing the lever, insert the wire into the hole, and then release the lever. Make sure that the terminals are gripping the bare wires, not the insulation. Note: While speaker set B is on, speaker set A is reduced to 5.1-channel playback. The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one surround back speaker, connect it to the left (L) SURR BACK SPEAKERS terminals. Front right speaker Speaker Set A Front left speaker Center speaker Front right speaker Front left speaker Speaker Set B Powered subwoofer Surround back right speaker Surround back left speaker Surround right speaker Surround left speaker 20