Onkyo TX-NR509 Owner Manual - Page 56

Controlling Other Components You can use the AV receiver's remote controller to control your other AV components. This section explains how to enter the remote control code (with the default underlined) for a component that you want to control: DVD, TV, CD, etc. Preprogrammed Remote Control Codes The following REMOTE MODE are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components. For details on controlling these components, see the pages indicated. BD/DVD Onkyo Blu-ray Disc player (➔ page 57) TV/CD Onkyo CD player (➔ page 56) PORT Onkyo Universal Port Option (➔ page 54) Entering Remote Control Codes You'll need to enter a code for each component that you want to control. 1 Look up the appropriate remote control code in the separate Remote Control Codes list. The codes are organized by category (e.g., DVD player, TV, etc.). 2 While holding down the REMOTE MODE to which you want to assign a code, press and hold down DISPLAY until the remote indicator lights (about 3 seconds). Note • Remote control codes cannot be entered for RECEIVER and ZONE 2. • Only TV remote control codes can be entered for TV. • Apart from RECEIVER, TV, and ZONE 2, remote control codes from any category can be entered for REMOTE MODE. However, these buttons also work as input selector buttons (➔ page 20), so choose a REMOTE MODE that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose TV/CD when entering its remote control code. 3 Within 30 seconds, use the number buttons to enter the 5-digit remote control code. The remote indicator flashes twice. If the remote control code is not entered successfully, the remote indicator will flash once slowly. Remote Control Codes for Onkyo Components Connected via V Onkyo components that are connected via V are controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example. 1 Make sure the Onkyo component is connected with an V cable and an analog audio cable (RCA). See "Connecting Onkyo V Components" for details (➔ page 17). 2 Enter the appropriate remote control code for REMOTE MODE, by referring to the previous section. ` 42157: Onkyo cassette tape deck with V ` 81993: Onkyo Dock with V 3 Press REMOTE MODE, point the remote controller at the AV receiver, and operate the component. Controlling Onkyo components without V If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that's not connected via V, use the following remote control codes: ` 30627: Onkyo DVD player without V ` 71817: Onkyo CD player without V ` 32900/33100/33500: Onkyo Blu-ray Disc player ` 32901/33104/33504: Onkyo HD DVD player ` 70868: Onkyo MD recorder without V ` 71323: Onkyo CD recorder without V ` 82990: Onkyo Dock without V Note • The remote control codes provided are correct at the time of printing, but are subject to change. En 56