Onkyo TX-NR757 User Manual - Page 47
Power On Volume, Maximum Volume.
View all Onkyo TX-NR757 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
>>Specifications >>Settings >>Listening Modes >>Playback Function >>Basic Manual Troubleshooting | Appendix ˙ 4� Volume Setting Item Volume Display Default Value Absolute Mute Level -∞dB Maximum Volume Off Power On Volume Last Headphone Level 0.0 dB Setting Details Switch the volume display between the absolute value and relative value. The absolute value 82.0 is equivalent to the relative value 0.0dB. "Absolute": Absolute value such as "0.5" and "99.5" "Relative": Relative value such as "-81.5dB" and "+18.0dB" • If the absolute value is set to 82.0, "82.0Ref" will appear on the display. Set the volume lowered from the listening volume when muting is on. Select a value from "-∞dB", "-40dB", and "-20dB". Set the maximum value to avoid too high volume. Select a value from "Off", "50" to "99". (When "Volume Display" is set to "Absolute") Set the volume level of when the power is turned on. Select a value from "Last" (Volume level before entering standby mode), "Min", "0.5" to "99.5" and "Max". (When "Volume Display" is set to "Absolute") • You cannot set a higher value than that of "Maximum Volume". Adjust the output level of the headphones. Select a value between "-12.0 dB" and "+12.0 dB". 4� Source Make settings for input sources, such as volume difference adjustments for each input selector for the connected equipment. ˙ 1� IntelliVolume Adjust the volume level difference between the devices connected to the unit. Select the input selector to configure. Setting Item IntelliVolume Default Value 0.0 dB Setting Details Select a value between "-12.0 dB" and "+12.0 dB". Set a negative value if the volume of the target device is larger than the others and a positive value if smaller. To check the audio, start playback of the connected device. • This function is not effective in Zone 2. ˙ 2� Name Edit Set an easy name to each input. The set name will be shown on the main unit display. Select the input selector to configure. Setting Item Name Edit Default Value Input name Setting Details 1. Select a character or symbol with the cursors and press ENTER. Repeat it to input 10 or less characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases Moves the cursor to the arrow direction. " ": Removes a character on the left of the cursor. " ": Enters a space. • Pressing CLEAR on the remote controller will remove all the input characters. 2. After inputting, select "OK" with the cursors and press ENTER. The input name will be saved. 15