Onkyo TX-NR757 User Manual - Page 9
Step2: Connect the Speakers, in case of, s 3 to 7
View all Onkyo TX-NR757 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
> Before start > Hookup > Setup > Playback > Part Names Step2: Connect the Speakers 1/2˝ (12 mm) 1 > Advanced Manual Troubleshooting | Appendix in case of: Pages 3 to 7 Connect 123456 for a 5.1-channel system. For a 7.1-channel system, select either surround back speakers or height speakers, and connect 78. Up to two powered subwoofers can be connected. The same signal is output from each of the SUBWOOFER jacks. Setup 0 The speaker configuration is set to 12345678 audio output by default. If there are speakers you won't be connecting, you need to change the settings in Initial Setup, "1. AccuEQ Room Calibration" (P19) so that the audio from those speakers you are not connecting is sent to other speakers. Note that if you are using height speakers, set "Speaker Channels" to "5.1.2 ch" in the setting screen. 2 1 Speaker cable, 2 Subwoofer cable Make sure the exposed wires of the speakers do not stick out of the speaker terminals when connecting. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated. 9