Onkyo TX-NR757 User Manual - Page 56

>>Specifications >>Settings >>Listening Modes >>Playback Function AccuEQ Room Calibration To enable equalizer for each speakers, select "On". Please select "All Channels", if you have same speakers for all channels. Please select "Except Front Left / Right", if front speakers are larger than other speakers. On (All Channels) On (Except Front Left / Right) Off Next If this is to be enabled, then normally you should select "On (All Channels)", and to disable just the front speakers you should select "On (Except Front Left / Right)". 7. Disconnect the speaker setup microphone. ˙ 2� Source Connection Check that each input source is connected correctly. Follow the guidance, select the input you want to confirm, start play of the selected player, and confirm that the images appear on the TV and that sound is played. ˙ 3� Network Connection Set up Wi-Fi connection with an access point such as a wireless LAN router. There are the following two methods of connecting by Wi-Fi: "Scan Networks": Search for an access point from this unit. Find out the SSID of the access point beforehand. "Use iOS Device (iOS7 or later)": Share the iOS device's Wi-Fi settings with this unit. If you select "Scan Networks", there are a further two choices of connection method. Check the following. "Enter Password": Enter the password (or key) of the access point to connect. "Push Button": If the access point has an automatic connection button, you can connect without entering a password. • If the SSID of the access point is not displayed, then in the screen listing the SSIDs, select "Other..." with the 24 cursor on the remote controller and press ENTER, then follow the onscreen instructions. Keyboard input Wi-Fi Setup SSID abcde f gh nopq r s t u 12345678 A/a Ɵ ơ When finished, select the "OK" key. i jklm vwx y z 90 - ^ \ ̺ OK All Erase A/a To switch between upper and lower case, select "A/a" on the screen and press ENTER. To select whether to mask the password with "＊" or display it in plain text, press MEMORY on the remote controller. Pressing CLEAR will delete all the input characters. • A confirmation screen asking you to agree to the privacy policy is displayed during network setting. Select "Yes" and press ENTER to indicate agreement. ˙ 4� Multi Zone Setup Set the output method for audio to ZONE 2 when you want to output audio to enjoy in a separate room from the main room. If you have connected speakers in a separate room with speaker cable, select "Using AV Receiver". If you have connected a pre-main amplifier in a separate room with an analog audio cable, select "with External Premain Amplifier". ˙ 5� Audio Return Channel If you have connected a TV that supports ARC, select "Yes". This unit's ARC setting turns on and you can listen to the TV's audio through this unit. • If you select "Yes", the HDMI CEC function is enabled and power consumption increases during standby. >>Basic Manual Troubleshooting | Appendix