Onkyo TX-SR373 Owners Manual - English - Page 15

2 Connecting a USB device It is possible to listen to two-channel audio using the USB interface on the front of this receiver. ... Switch the receiver into standby then connect your USB device to the USB terminal on the front panel of this receiver. • It is not possible to connect an iPod®/iPhone® or a similar device to this receiver and play back music files. • This receiver does not support a USB hub. • For instructions on playing the USB device, see Playing a USB device on page 20. NING PRESET ENTER RETURN MASTER VOLUME Plugging in the receiver Only plug in after you have connected all your components to this receiver, including the speakers. ... Plug the AC power cord into a convenient AC power outlet. CAUTION • Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Onkyo authorized service center or your dealer for a replacement. • The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g., when on vacation. USB SETUP MIC USB 5V / 0.5A AV RECEIVER TX-SR373 USB mass storage device This receiver Connecting your equipment 2 4 31 15