Panasonic DMPMS10 DMPMS10 User Guide - Page 28

Reference LED indicators Reference Error states are indicated by the INFO LED. Confirm the following items in correspondence to the state of INFO LED of this unit. ≥ If the state of the INFO LED does not change after performing the operations in the table below, contact your local Panasonic dealer. Messages Check the following when message are displayed on the screen. Cannot play. ¾ An attempt was made to play back incompatible content. POWER INFO  A INFO LED INFO LED state Description Flashes 6 times The remote control and this unit are using different codes. Turn on this unit by using the standby/on switch on this unit, and check "Remote Control ", which is displayed on the screen when you press a button on the remote control. Press and hold [OK] and the displayed number ("") for more than 5 seconds. Lights up The USB device is drawing too much power. Please disconnect or remove the USB device from the unit. The USB device may be incompatible. Cannot display on this unit. ¾ You tried to play a non-compatible image. $ This operation is not available. ¾ Some operations are unsupported by the unit. IP address is not set. ¾ The "IP Address" in "IP Address/DNS Settings" is Set the "IP Address", "Subnet Mask", and "Default Gateway". (Select the automatic address acquisition if necessary.) The current wireless network security setting is weak. It is recommended to change to a stronger security setting. ¾ Set a stronger network security level referring to the wireless router operating instructions. - 28 -