Panasonic KX-TGB85 Operating Instructions - Page 25

Programming 4 LOFFR to return to standby. Once the alarm is set to on, the icon is displayed. When the alarm goes on the icon flashes. Press any dial key to stop the sound. If set to "On once" then the alarm will turn off automatically after it sounds. If the alarm is set to "On daily" the alarm will sound at that time every day, to turn the alarm off select "Off" in the menu. Advanced settings Call block This feature allows the unit to block calls from specified phone numbers that you do not want to answer such as junk calls (Caller ID subscribers only). When a call is received, the unit does not ring while the caller is being identified. If the caller's phone number matches an entry in the block list, the unit emits no sound to the caller and "Blocked caller" is displayed for about 7 seconds, then disconnects the call. To disconnect the current call and add a phone number to the call block list You can press the LCALL BLOCKR button in the following situations to disconnect the current call and add a phone number to the call block list: - when an incoming call is being received - when an incoming call is being received by the answering system - when talking on an outside call Once a phone number has been added to the call block list, the unit will block calls from that phone number in the future. Handset / Base unit 1 Press LCALL BLOCKR under the situations shown above. ● The call block number is stored in the call block list and "Blocked caller" is displayed for about 7 seconds, then the call is disconnected. Switching unknown call block on/off Handset / Base unit 1 LCALL BLOCKR. 2 "Unknown call", press LOKR. 3 : LsR Select "On" or "Off", press OK L R to save. 4 Handset: LOFFR to return to standby. Base unit: LEXIT/STOPR to return to standby. Switching call block on/off Handset / Base unit 1 LCALL BLOCKR. d 2 L R "Block list", press LOKR. 3 "Block mode", press LOKR. 4 : LsR Select "On" or "Off", press OK L R to save. 5 Handset: LOFFR to return to standby. Base unit: LEXIT/STOPR to return to standby. Setting a number to be blocked You can store up to 50 phone numbers in the call block list. To activate this feature, you must turn the block mode on (page 25). Handset / Base unit ■ Adding call blocked number from the caller list 1 Proceed with the operation for your unit. d Handset: L R CID to open the caller list. Base unit: LCALL LISTR to open the caller list. 2 : LsR To the required entry. LOptionsR. d 3 L : R "Block number", press OK L R 2 times. 4 Proceed with the operation for your unit. Handset: LOFFR to return to standby. Base unit: LEXIT/STOPR to return to standby. ■ Adding call blocked number manually 1 LCALL BLOCKR. d 2 L R "Block list", press LOKR. d 3 L R "Block number", press LOKR. 4 LsR : to the next available slot, press LOKR. 5 Enter the number or pre ix you want to block. Press OK L R to con irm. 6 Handset: LOFFR to return to standby. Base unit: LEXIT/STOPR to return to standby. Note: When you store a phone number in the block list, you will need to store the full number including the area code for the number to be blocked. If you want to change/delete the block list number, follow the first 3 steps in "Adding call blocked number manually" above, and then For assistance, please visit http://shop.panasonic.com/support 25