Panasonic KX-TGF382M KX-TGF38x Owner's Manual - Page 76
FCC RF Exposure Warning, For assistance, please visit www.panasonic.com/support
View all Panasonic KX-TGF382M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Useful Information CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. R The handset may be carried and operated with only the specific provided belt-clip. Other non-tested belt-clips or similar body-worn accessories may not comply and must be avoided. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Notice: R FCC ID can be found inside the battery compartment or on the bottom of the units. Compliance with TIA-1083 standard: Telephone handsets identified with this logo have reduced noise and interference when used with T-Coil equipped hearing aids and cochlear implants. Compatible with Hearing Aid T-Coil T TIA-1083 Charge only mode The charge only mode is the dedicated mode to charge the backup batteries of the base unit. Do not use this mode if it is unnecessary because all functions except the base unit's battery charge is disabled with this feature on. Leave all the registered handsets on the chargers during use of the charge only mode. Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR.This will often reduce or eliminate interference. FCC RF Exposure Warning: R This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. R To comply with FCC RF exposure requirements, the base unit must be installed and operated 20 cm (8 inches) or more between the product and all person's body. R This product may not be collocated or operated in conjunction with any other antenna or transmitter. n To activate the charge only mode: 1 Disconnect the telephone line cord, the AC adaptor plug, and remove the batteries from the base unit with the corded handset placed on the cradle. 2 Press and hold 3, MZN, and MHOLDN at the same time, then insert the AC adaptor plug to the base unit. Keep on pressing these keys until: - a beep tone sounds, and - and the SP-PHONE indicator once turn on and off. 3 Release these keys. R LCD turns off. 4 Insert batteries. R The batteries are started to be charged. Note: R If the LCD is still on when you release the keys, the base unit is not in the charging only mode. Repeat from step 1. The charge only mode is 76 For assistance, please visit www.panasonic.com/support TGF38x(en)_1205_ver101.pdf 76 2014/12/05 10:20:16