Panasonic MJ-L500 Operating Manual - Page 9

How to clean ˔ Clean the appliance after every use. CAUTION: Unplug before cleaning. Do not use the following: ˔ Do not use benzine, thinner, alcohol, bleach, polishing powder, metal brush or nylon brush, otherwise the surface will be damaged. ˔ Do not clean the appliance with pointed object such as a toothpick or pin. Food pusher/lid Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well. * NOT dishwasher safe Frozen attachment Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well. * Dishwasher safe Rotating brush (P. EN17) About discoloration of parts Some discolouration of parts may occur upon using ingredients like carrot or leaf vegetable etc. Cleaning all parts immediately after each use will help to reduce stains. Squeezing screw/Filter Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well. t

6TF
UIF
DMFBOJOH
brush to clean the bottom surface of squeezing screw. t

8IFO
UIF
GJMUFS
JT
DMPHHFE
use the cleaning brush to clean. Juicing bowl (P. EN17) Motor housing Wipe with a well-wrung cloth. * NOT dishwasher safe * Dishwasher safe Accessories Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well. * Dishwasher safe Dishwasher safe parts ˔ Before putting the parts into a dishwasher, remove residue on the parts. ˔ Heat may cause cracking of parts. Always place the parts away from any heater or set a low temperature of heater. EN16 Rotating brush/Juicing bowl Wash with diluted dish soap (neutral) and a soft sponge. Then rinse thoroughly with water and dry well. After drying all the parts, assemble them correctly. ˔ Use the tip of cleaning brush handle to clean the spouts of the juicing bowl. (The inner surface may be scratched if you use the cleaning brush to clean it.) * NOT dishwasher safe To disassembling To assemble Push the rubber brush to the direction indicated by the arrow mark and take the part out from the gap. Note Do not pull the rubber brush hard. Rubber brush Gap Insert the upper/lower grooves of the rubber brush into the gap and then slide it all the way up/down both ends. ˔ To avoid damaging the juicer, make sure the upper and lower grooves are in the correct position. Gap Insert the groove to the projected part. Upper (Long) Lower (Short) Top view ˙ Gasket of the inner side of the KVJDJOH
CPXM To disassemble Pull the gasket up. To assemble Push the gasket into opening as figure bellow. Push Sectional view ˙ 3VCCFS
QMVH
PG
PVUFS
CPUUPN
PG
UIF
KVJDJOH
CPXM To disassemble To assemble Pull the rubber plug out in the direction of the arrow. ˔ Cannot be removed from the juicing bowl. Push the rubber plug into the opening in the direction of the arrow until there is no gap. ˙ About the rubber brushes, gasket and rubber plug ˔ After washing, drain off water well and then assemble them. Do not leave them unassembled. (Otherwise there is a risk of loss, choking on and swallowing of little parts by children, product failure, or leakage of juice.) Storage ˔ To avoid formation of rust, dry the parts after washing. ˔ To avoid failure, do not place the motor housing up-side down. ˔ To move the juicer, separate the juicing bowl from the motor housing and hold them with both hands. (P. EN7). ˔ Store the appliance in a place that is beyond the reach of young children. EN17 English