Panasonic SAPM91D SAPM91 User Guide - Page 23

The radio The radio SUBWOOFER H.BASS SOUND ALL DISC DISC GROUP STOP QUICK REPLAYCM SKIP QUICK OSD FUNCTIONS Manual tuning 1 2 3 TUNER / AUX Select "FM" or "AM". Select the frequency of the desired station. Adjust the volume. • Press and hold [t] or [y] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found. "ST" is displayed when a stereo FM broadcast is being received. If noise is excessive in FM Press [PLAY MODE] to display "MONO". To cancel, press [PLAY MODE] again. The mode also cancels when you change the frequency. ■ FM frequency step (main unit only) The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated to 0.1 MHz steps. 1.Select "FM". 2.Press and hold [TUNER/AUX] on the main unit. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. Note Any preset stations are cleared by this procedure. Preset them again. Preset tuning Preset channels to make selection simpler. You can set up to 15 stations each in the FM and AM bands. Automatic presetting Tune to the frequency where presetting is to begin (➡ see above). Manual presetting Tune to the desired station (➡ see above). Press and hold. (release when "AUTO" appears) 1 2 The tuner presets the stations it can receive into the channels in ascending order. When finished, the last station to be set is played. Press to select. ("PGM" appears) Press while the station is flashing to select the channel. The station occupying a channel is erased if another station is preset in that channel. Selecting channels 1. Press [TUNER/AUX] to select "FM" or "AM". 2. Press the numbered buttons or [u2/REW] or [i1/FF] to select the channel. RQT7932 23