Panasonic U1 Panaboard - Page 15

Operating Instructions Paper Jams Remove paper jams by the following procedure when copy paper does not come out of the output port or when " " flashes on the Multi-Copy/Error Indicator. 1 Push down the printer open lever to open the printer door. 2 Remove the thermal transfer film with both hands. Paper Jams 4 Install the thermal transfer film. • Refer to steps 3 and 4 in the section of "Installing the Thermal Transfer Film" on page 10. • " " flashing on the Multi-Copy/Error Indicator will go out. Note • If " " is still flashing after closing the printer door, make sure that the thermal transfer film has been installed properly and tightened. • The printer door should be closed to make copies properly. Confirm both latches are locked. If the flashing " " does not go out after the foregoing procedure has been performed; this may indicate that the paper feeder is not functioning properly. Reload the copy paper by following the steps given below. 1 Turn the power off. ON OFF 3 Remove the jammed paper. 2 Open the paper cover and remove all the copy paper remaining inside the unit's paper cover. Jammed paper Note • The copy paper will slightly resist being removed, but may be pulled out without problems. 15