Panasonic U1 Panaboard - Page 34

Electronic Board Operations Check After assembling the electronic board, perform the procedures presented in the following table to make sure it functions properly. Step Points to Check Symptom Solutions 1 Turn on the power switch. " " flashes after " " lights up. (If not) (Normal operation) Check power cord. (See step 4 on page 33.) 2 Open the printer door and attach the " " flashes. accessory thermal transfer film, then (If not) close the printer door. • Installing Thermal Transfer Film procedure (refer to the Operating Instructions on page 10) (Normal operation) Check thermal transfer film. 3 Open the paper cover and insert " " lights up. ordinary Letter test paper, then close (If not) the paper cover. • Loading Copy Paper procedure (refer to the Operating Instructions on page 11) (Normal operation) Check copy paper. 4 Open the printer door. " " flashes. (If not) (Normal operation) *1 5 Close the printer door. " " lights up. (If not) (Normal operation) *1 6 Press . Press . Screen is fed. The screen film surface is not fed smoothly. (Normal operation) *1 There are strange noises. 7 Use the accessory marker to draw " " lights up and three copies are made. (Normal operation) a large filling the entire Three copies are not made. *1 copyable area of the screen film surface. The entire readable area is not printed. • Copyable area (refer to the Operating Instructions on There are strange noises or paper jams during the copying process. page 7) Press twice. Multiple sheets of paper are fed through at the same time. Press . 8 Press to move the screen The Contrast/Remaining Film (Normal operation) indicator light is turned on and one film surface. Write letters, etc. with copy is made. the marker. Press once. The Contrast/Remaining Film *1 indicator light is not turned on. Press . The image is not copied properly. There are strange markings on the copy sheet (e.g., stripes or lines). 9 Press once. The Contrast/Remaining Film indicator light is turned off. (Normal operation) (If not) *1 *1 Contact the store or dealer from which the unit was purchased. 34