Pfaff admire air 5000 Manual - Page 11

Upper Cutter Turn off the main power switch and unplug the machine. A Deactivate the Upper Cutter Deactivate the upper cutter for flatlock, pintucking, etc. • Turn the handwheel toward you until the upper cutter (A) is raised to the highest position. • Open the front cover. • Push the the movable cutter knob (B) towards the co- ver (C). While pressed, turn the knob clockwise until the cutter clicks into the locked position (D). B Reactivate the Moveable Upper Cutter C D E • Open the front cover. • Push the movable cutter knob towards the cover (C). While pressed, turn the knob clockwise until the cutter is activated again (E). 2-thread Overlock Converter Turn off the main power switch and unplug the machine. A C Engaging 2-thread overlock stitches are sewn using one needle thread and the lower looper thread. Before sewing, the 2-thread overlock converter must be attached to the upper looper. • Open the front cover. • Raise the needle. • Insert the pin of the needle holder into the small hole (A) of the 2-thread overlock converter (B). Turn the 2-thread overlock converter counter-clockwise until its hook matches the tip of the upper looper (C). (Make sure that the needle holder does not touch the upper knife). Carfully push the 2-thread overlock converter backwards so that the hook (D) goes behind the bulge (E) of the upper looper and into the hole (F). B D E Upper view of the upper looper F Rear view of the upper looper Disengaging A Insert the pin of the needle holder into the small hole in the 2-thread overlock converter (A). Carefully push the 2-thread overlock converter backwards (B) and turn it clockwise until the hook comes over the bulge. 2-thread overlock converter Turn the 2-thread overlock converter until it clicks into engaged the original position (C). B C Remove the needle holder from the 2-thread overlock con- verter. ABOUT YOUR MACHINE - 11