Pfaff admire air 5000 Manual - Page 8

Front and Flat Bed Extension Covers Front Cover Open by pushing the cover to the right as far as it will go and then pull it toward you. Close it again by pulling the cover upward and then sliding it to the left until it locks. Note: The front cover has a safety switch and the machine will not sew if the front cover is open. Flat Bed Extension Cover Pull and swing the cover to the left to open. Swing it back and push in place to close. Note: The flat bed extension cover has a safety switch and the machine will not sew if it is opened. Waste Tray A The waste tray collects trimmings. Make sure the trim falls into the tray while sewing. Empty the tray after sewing. Place the tray along the edge of the flat bed extention (A). Push the waste tray towards the front cover inserting the tabs into the slit under the front cover (B). Push until it clicks in place. Pull the waste tray toward you to remove it. B Handwheel By turning the handwheel you can raise and/or lower the A needles manually. Always turn the handwheel toward you. B When threading, adjusting the stitch finger lever or connecting/disconnecting the 2-thread overlock converter, the hand wheel should be set to locked position. Put the "Threading/Sewing" switch in "Threading posi- tion" (A). To lock the handwheel, match the mark on the cover (B) with the mark on the handwheel (C). C 8 - ABOUT YOUR MACHINE