Pfaff admire air 5000 Manual - Page 17

place. Lower it again until it knocks into place.

Get Pfaff admire air 5000 PDF manuals and user guides View all Pfaff admire air 5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Set the Threading/Sewing switch to "Threading" position (G) by turning it to the right. G H Turn the handwheel slowly toward you until the mark on the wheel matches the mark on the cover (H). The hand wheel will click and is locked in threading position. Turn the looper selection lever to the left (I) to activate I J the upper looper threading. Using the tweezers, insert the end of the thread 2 cm or more into the upper looper threading hole (J). Note: • Trim the thread end so that it can be inserted into the threading hole smoothly. • If threading special threads, such as wooly nylon, etc., K L refer to pages 18-19. Raise the looper threader lever (K) until it clicks into place. Lower it again until it knocks into place. Make sure that the thread comes out from the hole of the upper looper tip (L). If the thread does not come out from the hole, follow the procedure from step "J" again. Set the Threading/Sewing switch (G) to "Sewing" po- M sition (M). Pull 4˝ (10 cm) of the thread under the toe of the foot, and back between the presser fot foot and the upper N cutter (N). Close the front cover and lower the presser foot lifter. GETTING READY TO SEW - 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
K
L
N
M
G
H
I
J
GETTING READY TO SEW – 17
Set the Threading/Sewing switch to “Threading” posi
-
tion (G) by turning it to the right.
Turn the handwheel slowly toward you until the mark
on the wheel matches the mark on the cover (H). The
hand wheel will click and is locked in threading posi-
tion.
Turn the looper selection lever to the left (I) to activate
the upper looper threading.
Using the tweezers, insert the end of the thread 2 cm or
more into the upper looper threading hole (J).
Note:
•
Trim the thread end so that it can be inserted into the
threading hole smoothly.
•
If threading special threads, such as wooly nylon, etc.,
refer to pages 18-19.
Raise the looper threader lever (K) until it clicks into
place. Lower it again until it knocks into place.
Make sure that the thread comes out from the hole of
the upper looper tip (L).
If the thread does not come out from the hole, follow
the procedure from step ”J” again.
Set the Threading/Sewing switch (G) to “Sewing” po
-
sition (M).
Pull 4˝ (10 cm) of the thread under the toe of the foot,
and back between the presser fot foot and the upper
cutter (N).
Close the front cover and lower the presser foot lifter.