Philips HTB5544D User manual - Page 34

Note •• AM and digital radio are not supported. •• If no stereo signal is detected, you are prompted to install the radio stations again. 1 Connect the FM antenna to the FM ANTENNA on your home theater. • For the best reception, place the antenna away from your TV or other sources of radiation. 2 Press RADIO on the remote control to switch to radio source. »» If you have already installed the radio stations, the last channel that you listened to is played. »» If you have not installed any radio stations, the message AUTO INSTALL...PRESS PLAY appears on the display panel. Press (Play) to install radio stations. 3 Use the remote control to listen or to change radio stations. Play buttons Button / or Alphanumeric buttons Navigation buttons BACK Action Select a preset radio station. Left/Right: Search for a radio station. Up/Down: Fine tune a radio frequency. Press to stop the installation of radio stations. Press and hold to erase the preset radio station. OPTIONS SUBTITLE Manual: 1) Press OPTIONS. 2) Press / to select your preset. 3) Press OPTIONS again to store the radio station. Automatic: Press and hold for three seconds to reinstall the radio stations. Toggle between the stereo and mono sounds. Tuning grid In some countries, you can toggle the FM tuning grid between 50 kHz and 100 kHz. 1 Press RADIO on the remote control to switch to radio source. 2 Press . 3 Press and hold (Play) to toggle between 50 kHz or 100 kHz. MP3 player Connect a MP3 player to play audio files. What you need • An MP3 player. • A 3.5mm stereo audio cable. 1 Using the 3.5mm stereo audio cable, connect the MP3 player to the AUDIO-IN connector on your home theater. • If you use 6.5mm stereo audio cable, connect the MP3 player to your home theater using a 3.5mm - 6.5mm converter jack. 2 Press SOURCE repeatedly until AUDIO- IN appears on the display panel. 3 Press the buttons on the MP3 player to select and play audio files. 34 EN