Pioneer DVR-533H-S Owner's Manual - Page 110

14 Additional information Hints on installation We want you to enjoy using this unit for years to come, so please bear in mind the following points when choosing a suitable location for it: Do... Use in a well-ventilated room. Place on a solid, flat, level surface, such as a table, shelf or stereo rack. Don't... Use in a place exposed to high temperatures or humidity, including near radiators and other heatgenerating appliances. Place on a window sill or other place where the recorder will be exposed to direct sunlight. Use in a dusty or damp environment or in a room where it will be exposed to excessive cigarette smoke. Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use. Use near a television or monitor as you may experience interference-especially if the television uses an indoor antenna. Use in a kitchen or other room where the recorder may be exposed to smoke or steam. Use on a thick rug or carpet, or cover with cloth-this may prevent proper cooling of the unit. Place on an unstable surface, or one that is not large enough to support all four of the unit's feet. Glossary Analog audio An electrical signal that directly represents sound. Compare this to digital audio which can be an electrical signal, but is an indirect representation of sound. See also Digital audio. Aspect ratio The width of a TV screen relative to its height. Conventional TVs are 4:3 (in other words, the screen is almost square); widescreen models are 16:9 (the screen is almost twice as wide as it is high). Chapter Just as a book is split up into several chapters, a title on the HDD/a DVD disc is usually divided into chapters. See also Title. Digital audio An indirect representation of sound by numbers. During recording, the sound is measured at discrete intervals (44,100 times a second for CD audio) by an analog-todigital converter, generating a stream of numbers. On playback, a digital-to-analog converter generates an analog signal based on these numbers. See also Sampling frequency and Analog audio. Dolby Digital Moving the recorder If you need to move the recorder, first remove the disc, if there's one loaded, and close the disc tray. Next, press STANDBY/ON to switch the power to standby, checking that the POWER OFF indication in the display goes off. Wait at least two minutes. Lastly, disconnect the power cord. Never lift or move the unit during playback or recording-discs rotate at a high speed and may be damaged. Dolby® Digital Stereo Creator enables consumers to create stereo DVD-Videos with stunning Dolby Digital sound tracks at home. The technology, when utilized instead of PCM recording, also saves recordable disc space, allowing for higher video resolution or extended recording time on each DVD. DVDs mastered using Dolby Digital Stereo Creator will play back on all DVDVideo players. Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories. 110 En