Pioneer FH-P800BT Owner's Manual - Page 46
Adjusting loudness, Using subwoofer output, Audio Adjustments - equalizer
UPC - 012562886657
View all Pioneer FH-P800BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Section 03 Audio Adjustments 3 Push MULTI-CONTROL left or right to select the equalizer band to adjust. Each time MULTI-CONTROL is pushed left or right, equalizer bands are selected in the following order: 50HZ-125HZ-315HZ-800HZ-2KHZ- 5KHZ-12.5KHZ 4 Push MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pushed up or down, the level of the equalization band increases or decreases. +6 to -6 is displayed as the level is increased or decreased. # You can then select another band and adjust the level. 5 Press BAND to cancel the 7-band graphic equalizer adjustment. Adjusting loudness Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Display the audio menu. Refer to Introduction of audio adjustments on page 44. 2 Use MULTI-CONTROL to select LOUDNESS. 3 Press MULTI-CONTROL to turn loudness on. Loudness level (e.g., MID) appears in the display. # To turn loudness off, press MULTI-CONTROL again. 4 Push MULTI-CONTROL left or right to select a desired level. Each time MULTI-CONTROL is pushed left or right, level is selected in the following order: LOW (low)-MID (mid)-HIGH (high) Using subwoofer output This unit is equipped with a subwoofer output which can be turned on or off. 1 Display the audio menu. Refer to Introduction of audio adjustments on page 44. 2 Use MULTI-CONTROL to select SUB W1. 3 Press MULTI-CONTROL to turn subwoofer output on. NORMAL appears in the display. Subwoofer output is now on. # To turn subwoofer output off, press MULTI-CONTROL again. 4 Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and REVERSE appears in the display. Push MULTI-CONTROL right to select normal phase and NORMAL appears in the display. Adjusting subwoofer settings When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. Only frequencies lower than those in the selected range are outputted from the subwoofer. ! When the subwoofer output is on, you can select SUB W2. 1 Display the audio menu. Refer to Introduction of audio adjustments on page 44. 2 Use MULTI-CONTROL to select SUB W2. 3 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50HZ-63HZ-80HZ-100HZ-125HZ 46 En