Pioneer HTP-710 Operating Instructions - Page 21
Model label, Black (-), Y-cable, Front right: Red
View all Pioneer HTP-710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Speaker Setup (HTP-610) 01 English Français Deutsch Italiano Español Nederlands 2 (When mounting center speakers to right and left) Stack the speakers and fix with the bracket. Each speaker is provided with a color-coded indicator on the model label on the rear side to assist identification. Refer to the color indicators and install the speakers correctly. As shown in the illustration, stack the speakers. Align the bracket with the respective upper and lower screw holes as shown in each figure below and fasten the screws securely. Model label Left Green Center speaker Right Green Color indicator White Front speaker Red 3 Connect each speaker. Connect the wires to the speaker. Each speaker in the illustration can be identified by means of the color-coded indicator provided on the rear-surface label. Front left: White Front right: Red Center: Green Surround left: Blue Surround right: Gray Match the color-coded wire with the color indicator on the label, then insert the colorcoded wire into the red (+) side and the other wire into the black (-) side. Black (-) Red (+) Color-coded wire Bracket Screw Center speaker Front speaker • When connecting the center speakers, connect the Y-cable dual end to the two center speakers in the same way. CAUTION • Do not attempt to carry the speakers when they are connected with the bracket. Doing so may cause damage to the bracket or worsen damage to the bracket and speakers in the event they are dropped. Y-cable To receiver subwoofer 21 En