Pioneer HTP-710 Operating Instructions - Page 27

Speaker Setup (HTP-FS510) 01 English Français Deutsch Italiano Español Nederlands Attaching the speakers The front speaker can be hung vertically or horizontally on the wall. Use one hole to hang it vertically and two holes to hang it horizontally. When installing the speaker horizontally, set it up so that the speaker terminal on the back side of the speaker is on the outside on the end of the surface, farthest away from the other speaker. Speaker terminal Speaker terminal Mounting holes Front right Front left Additional notes on speaker placement • Install the front left and right speakers at an equal distance from the TV. Precautions: • Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure. • The front speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this case happens, turn the power switch of the television set OFF, and turn it ON after 15 min. to 30 min. If the problem persists, place the speaker system away from the television set. • The subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to the subwoofer. • Do not attach the subwoofer to a wall or ceiling. They may fall off and cause injury. For Enhanced Sound Quality A home theater system can be easily constructed using just the front (right/left) speakers and the subwoofer of this set, but by adding optional S-SWR5CR speaker systems, you can enjoy genuine 5.1 channel surround sound. Take the following points into account when connecting the optional speaker systems: • When the contents of these Operating Instructions from chapter 2 on describe a specific model, use those portions dealing with the HTP-610. • For information regarding the installation and connection of optional speaker systems, consult the information provided with the optional speaker systems, together Speaker Setup (HTP-610) on page 20 portion of these Operating Instructions. • See Automatically setting up for surround sound (MCACC) on page 51 to set up your system again using MCACC. 27 En