Pioneer HTP-710 Operating Instructions - Page 25

Speaker Setup (HTP-FS510) 01 4 Insert the speaker cable from the hole behind the base through to the pole. • When connections are completed, secure the speaker cables. Fix the cables to the groove in the speakers. English Français Deutsch Italiano Español Nederlands 5 Connect each speaker. Connect the wires to the speaker. Each speaker in the illustration can be identified by means of the color-coded indicator provided on the rear-surface label. Front left: White Front right: Red Match the color-coded wire with the color indicator on the label, then insert the colorcoded wire into the red (+) side and the other wire into the black (-) side. Black (-) Red (+) Color-coded wire Connect the other end to the color-coded speaker terminals on the rear of the receiver subwoofer. Color-coded tab (+) Color-coded wire Black (-) CAUTION • These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. • Only those speakers supplied, or purchased as an officially supported option, should be connected to this system. • Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other amplifier may result in malfunction or fire. • After connecting the plugs, pull lightly on the cables to make sure that the ends of the cables are securely connected to the terminals. Poor connections can create noise and interruptions on the sound. • If the cable's wires happen to be pushed out of the terminals, allowing the wires to come into contact with each other, it places an excessive additional load on the amp. This may cause the amp to stop functioning, and may even damage the amp. 25 En