Pioneer PRO-910HD Owner's Manual - Page 17

Preparation 07 Allowed operation range of the remote control unit Operate the remote control unit while pointing it toward the remote control sensor (t) located at the bottom right of the front panel of the Plasma Display. The distance from the remote control sensor must be within 7 m (276 inches) and the angle relative to the sensor must be within 30 degrees in the right, left, upward, or downward direction. Installing the Plasma Display Over 50 cm (19 11/16 inches) Over 10 cm (3 15/16 inches ) 30º 7 m (276 inches) Remote 30º control sensor Locating • Avoid direct sunlight. Maintain adequate ventilation. • The length of the system cable used to connect the Plasma Display and the Media Receiver is about 3 m (118 inches). • Because the Plasma Display is heavy, be sure to have someone help you when moving it. • If you place anything on the top of the Media Receiver it will not receive enough ventilation and will not operate properly. When the remote control unit does not func- tion properly • When any obstacle exists between the remote control unit and the remote control sensor, the remote control unit may not function. • Allow enough space around the upper and back parts when installing to ensure ventilation around the backside. • As the batteries become empty, the remote control unit can function within a shorter distance from the remote control sensor. Replace the batteries with new ones early enough. Using the optional PIONEER stand • For details on installation, refer to the instruction manual provided with the stand. • The Plasma Display emits very weak infrared rays from its screen. If you place such equipment operated through infrared remote control as a VCR nearby, that equipment may not receive commands from its remote control unit properly or entirely. If this is the case, place that equipment at a location far enough from the Plasma Display. • Depending on the installation environment, infrared rays from the Plasma Display may not allow this system to properly receive commands from the remote control unit or may shorten allowable distances between the remote control unit and the remote control sensor. The strength of infrared rays emitted from the screen differs, depending on images displayed on the screen. • This product may be used only with model PDK-TS04 stand, use with other stands may result in instability causing possible injury. Using the optional PIONEER speakers • For details on installation, refer to the instruction manual provided with the speaker. Operating Environment Operating environment temperature and humidity: +0°C to +40°C (+32°F to +104°F); less than 85% RH (cooling vents not blocked) Avoid installing at the following locations: • Under direct exposure to sunlight • Under strong artificial light • In high humidity • Poorly ventilated 17 En PDP-ELITE-Eng (17-27) 17 9/9/03, 11:44