Pioneer PRO-910HD Owner's Manual - Page 27
Plasma Display rear view, Media Receiver rear view
View all Pioneer PRO-910HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Preparation 07 Connecting the power cord Connect the power cord after all component connections have been completed. Plasma Display (rear view) Power cord Media Receiver (rear view) SERVICE ONLY IN OUT CONTROL VCR CONTROL IN OUT IN OUT S-VIDEO DIGITAL OUT OPTICAL INPUT 2 VIDEO R-AUDIO-L VIDEO (TS) S400 DTV-ANTENNA IN INPUT 1 R-AUDIO-L COMPONENT VIDEO Y CB/PB CR/PR A ANTENNA/CABLE B MONITOR OUT S-VIDEO VIDEO R-AUDIO-L S-VIDEO R-AUDIO-L INPUT 3 Y CB/PB CR/PR AC INLET BLACK WHITE SYSTEM CABLE Noise filter Partially eliminates noise caused by the power source. AC INLET Power cord Noise filter Partially eliminates noise caused by the power source. • Use only the power cord provided. • Do not use a power supply voltage other than that indicated as this may cause fire or electric shock. • For the Plasma Display System, a three-core power cord with a ground terminal is used for efficiency protection. Always connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line. • Always turn off the power of the Plasma Display and Media Receiver when connecting the power cords. • Disconnect the power cord from the power outlet when the Plasma Display System is not going to be used for a long period of time. 27 En PDP-ELITE-Eng (17-27) 27 9/9/03, 11:44