Pioneer PRO-910HD Owner's Manual - Page 30
Using CH, on the remote control unit, Using CH RETURN on the remote control unit, Using 0 - 9 on
View all Pioneer PRO-910HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
08 Basic Operations Plasma Display (right view) CHANNEL +/- Channel display 8 AAA STEREO STANDARD FULL Watching conventional TV channels Unless you set up conventional TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see "Setting up conventional TV channels" on page 41. • Conventional TV channels in this manual designate TV channels that are received through the conventional VHF/UHF frequencies or conventional cable TV channels. Selecting the antenna After confirming that the Mode switch on the remote control unit has been set to "TV", press ANT on the remote control unit to select antenna A or B. • Make this selection depending on the connections to the antenna input terminals on the Media Receiver (pages 24 to 26). Changing channels Using CH +/- on the remote control unit • Press CH + to increase the channel number. • Press CH - to decrease the channel number. • CHANNEL +/- on the Plasma Display operates the same as CH +/-. Using CH RETURN on the remote control unit Press CH RETURN to switch the currently tuned channel to the previously tuned channel. Press CH RETURN again to switch back to the currently tuned channel. Using 0 - 9 on the remote control unit Select channels directly by pressing buttons 0 to 9. EXAMPLE • To select channel 5 (1-digit channel), press 5. • To select channel 25 (2-digit channel), press 2, followed by 5. • To select channel 125 (3-digit channel), press 1, then 2, followed by 5. • After entering a channel number, you may press CH ENTER to tune in the channel more quickly. 30 En PDP-ELITE-Eng (28-37) 30 9/9/03, 11:44