Pioneer SC-LX501 Basic Manual English/French - Page 25

> Before start > Hookup > Setup > Playback > Part Names Others a b c d e Listening To the Radio 1. Press TUNER (a) on the remote controller repeatedly to select either "AM" or "FM" on the display. 2. Press MODE (c) on the remote controller, so that the "TunMode: Auto" is displayed on the display. 3. When you press the  /  cursor (b) buttons on the remote controller, automatic tuning starts, and searching stops when a station is found. When tuned into a radio station, the "TUNED" indicator on the display lights. You can preset up to 40 stations. 1. Tune into the AM/FM radio station you want to register. 2. Press +Fav (d) on the remote controller so that the preset number on the display flashes. 3. While the preset number is flashing (about 8 seconds), repeatedly press the  /  cursor (b) buttons on the remote controller to select a number between 1 and 40. 4. Press +Fav (d) again on the remote controller to register the station. When registered, the preset number stops flashing. To select a preset radio station, press the  /  cursor (b) buttons on the remote controller. 0 To delete a preset station, press the  /  cursor (b) buttons on the remote controller to select the preset number you want to delete, press +Fav (d) on the remote controller and then press CLEAR (e) while the preset number is flashing. When deleted, the number on the display goes off. Frequency step setting Press the button on the remote controller to select "System Setup" - "Miscellaneous" - "Tuner" - "AM/FM Frequency Step" or "AM Frequency Step" and select the frequency step for your area. Note that when this setting is changed, all radio presets are deleted. d e b c a Multi-zone Play En 1. While holding down MODE (a) on the remote controller, press ZONE 2 (b) for 3 or more seconds until the remote indicator blinks twice. 0 The remote controller switches to the mode for controlling ZONE 2. To return the remote controller to main room control mode: While holding down MODE (a) on the remote controller, press MAIN (c) for 3 seconds or more until the remote indicator flashes once. 2. Point the remote controller at the main unit and press Í (d). "Z2" lights on the main unit display. 3. Press the input selector button (e) of the input to be played in the separate room. On the main unit, after pressing ZONE CONTROL, within 8 seconds turn the INPUT SELECTOR dial to select the input to be played in the separate room. 0 You can only select the same inputs for the main room and separate room with the "NET" or "BLUETOOTH", or "USB" input selector. If you have "NET" selected in the main room and then select "USB" in the separate room, the main room also switches to "USB". You cannot select different stations for the main room and separate room with the AM/FM radio. 0 DSD and Dolby TrueHD audio signals are not output to ZONE 2 when selected with the "NET", "USB" input selector. 4. To adjust the volume on the power amplifier in the separate room or the Zone Speaker, adjust with VOL+/- on the remote controller. To control on the main unit, press ZONE CONTROL and within 8 seconds, adjust 25