Pioneer VSX-21 Operating Instructions - Page 13

SET UP Connections Speakers • Use speakers with a nominal impedance of 6 Ω to 16 Ω. • The front speaker B terminal is only used in stereo mode (Not available during DVD 5.1 channel, DSP mode, or Dolby/ DTS mode). • When you use the speaker on your TV as a center speaker, please connect the CENTER PREOUT jack on this unit to the audio input jack on your TV. In this case, the center speaker shown below is unnecessary. Refer to the instruction manual supplied with the TV or monitor you are connecting to for more information. • You can set the configuration of your speaker system, whether the sizes of the speakers are large or small, and whether or not you have a sub woofer connected. (Refer to pages 16 to 18) Front Speakers L R Center Speaker C TV (To be used as the center speaker) Surround Speakers SL SR (To the audio input) OPERATION ANTENNA DIGITAL IN OPT 1 PCM/ /DTS FM UNBAL 75Ω OPT 2 OPT 3 DVD 5.1 CH INPUT SURROUND L SUBWOOFER AM LOOP ANTENNA S2 TO OUT MONITOR TV OPT DIGITAL OUT COAX R IN L PCM/ /DTS DIGITAL IN R CENTER OUT PLAY REC MD/TAPE 1 CONTROL OUT IN VIDEO OUT IN IN OUT PLAY REC CD TAPE 2 MONITOR IN IN IN OUT S2 S2 S2 S2 IN IN IN OUT IN IN IN OUT TV/ DVD/ SAT LD DVD 5.1 CH FRONT VCR 1 IN OUT S2 S2 VIDEO IN OUT IN OUT L R VCR 2 Powered Sub Woofer INPUT Connection methods that differ from the example shown in this manual may be available. For more details, refer to the instruction manual supplied with the sub woofer. FRONT PREOUT L R FRONT SPEAKERS R L CENTER PREOUT L SORROUND PREOUT R SUBWOOFER PREOUT CENTER SPEAKER R L SURROUND SPEAKERS A B CAUTION: SEE INSTRUCTION MANUAL ATTENTION: SEE INSTRUCTION MANUAL 6~LESS THAN 8Ω /SPEAKER 6~MOINS DE 8Ω /HAUTPARLEUR 8~16Ω / SPEAKER 8~16Ω / SPEAKER IMPEDANCE SELECTOR AC OUTLET AC 120V 60Hz Use speakers with nominal impedance of 6 Ω to 8 Ω or 8 Ω to 16 Ω. • When using speakers with impedance of at least 6 Ω but less than 8 Ω, set the IMPEDANCE SELECTOR to the "6~LESS THAN 8 Ω" position. • When using 8 Ω to 16 Ω, set the IMPEDANCE SELECTOR to "8~16 Ω" position. Be sure to complete all other connections before connecting this unit to the AC power source. 7 Speaker terminals Twist exposed wire strands together. 3/8 in.(10mm) Turn counter-clockwise to loosen, and insert the wire. Then turn clockwise to tighten. 13