Pioneer VSX-21 Operating Instructions - Page 23
Clearing the Remote Control Settings - or vsx 23
UPC - 012562957067
View all Pioneer VSX-21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Preparations SET UP 3 Press % or fi repeatedly to display the name of the component's manufacturer. SIGNAL SELECT ANALOG SP A SIGNAL SELECT ANALOG dB ("VCR" is displayed on VSX-D508) SIGNAL SELECT ANALOG SP A dB SP A dB SIGNAL SELECT ANALOG SIGNAL SELECT ANALOG SP A dB SP A dB A list of all available preset codes is provided on page 56. 4 Point the remote toward the component to be controlled, enter the 3 digit setup code. When you enter the setup code, the remote emits a power ON/OFF signal. If the component turns ON or OFF, you have entered the proper code. If the component does not turn ON or OFF and there is more than one setup code, press ! or ⁄ to select another code in step 3 or try inputting another code (starting again from step 2). Some manufacturers use several sets of remote control signals and the first code may not correspond to your component. SIGNAL SELECT ANALOG SP A dB SIGNAL SELECT ANALOG SP A dB SIGNAL SELECT ANALOG SP A dB SIGNAL SELECT ANALOG SP A dB Repeat steps 2 through 4 to assign preset codes for as many components as necessary. 5 Press COMMANDER SET UP to exit the preset mode. The remote control returns to the previous operation mode. memo • When operating a PIONEER'S DVD/LD player, set the manufacturer code to "000" in the preset mode. • All codes enrolled in the manufacturer code list can be set even if a code is not displayed. • RECEIVER cannot be preset. Clearing the Remote Control Settings DSP MODE MIDNIGHT 12 34 Clears all presets and restores factory installed presets. CH.SELECT TEST TONE ATT SIG.SELECT 56 7 8 CN.LEVEL EFFECT 0 9 0 +10 MEMU CLASS TV/VCR FUNCTION DIRECT FL DIMMER Press the COMMANDER SET UP and 0 at the same time for more 3 seconds. MODE CHECK COMMANDER SET UP Î AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT COMMANDER SET UP • All the multi-control buttons on the remote control blinks. After blinking three times, all the settings are canceled. 23