Pioneer VSX-21 Operating Instructions - Page 29
Switching ANALOG/DIGITAL Signal Input
UPC - 012562957067
View all Pioneer VSX-21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Sound Modes Switching ANALOG/DIGITAL Signal Input The input of the component set in the digital input setting (Refer to page 20, 21) can be switched to an analog or digital input signal by pressing the SIGNAL SELECT button. SET UP OPERATION RECEIVER TV MUTING FQ TV FUNC + ENTER - FQ VOL VOL CHANNEL MULTI CONTROL DVD/LD TV/SAT CD VCR 1 TVCONTROL TUNER VCR 2 RECEIVER MD/TAPE DSP MODE MIDNIGHT 12 34 CH.SELECT TEST TONE ATT SIG.SELECT 56 7 8 CN.LEVEL 90 EFFECT +10 MEMU CLASS TV/VCR FUNCTION DIRECT FL DIMMER MODE CHECK COMMANDER SET UP Î AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT 1 Press SIG. SELECT on the remote control or SIGNAL SELECT on the front panel to select the input signal corresponding to the source component. Each press switches between ANALOG and DIGITAL signal selection. SIGNAL SELECT ANALOG SIGNAL SELECT ANALOG SP A SIGNAL SELECT DIGITAL SIGNAL SELECT DIGITAL SP A SIG.SELECT 2 While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input SIGNAL SELECT DIGITAL AC-3 SIGNAL SELECT DIGITAL AC-3 SP A When a Dolby Digital signal is input. SIGNAL SELECT SIGNAL SELECT DIGITAL DTS SIGNAL SELECT DIGITAL DTS SP A When a DTS signal is input. memo • SIGNAL SELECT is fixed in the "ANALOG" position for components not assigned to one of the four digital input jacks. • Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from the digital output, set SIGNAL SELECT to "ANALOG". • This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and 48kHz), DTS digital signal formats. With digital signal formats other than these, set SIGNAL SELECT to "ANALOG". • When an LD or CD player compatible with DTS is played back with SIGNAL SELECT set in "ANALOG", digital noise is output caused by playing back the DTS directly (no decoding). To prevent noise, you need to make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT to "DIGITAL". • Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your DVD player. 29