Pioneer VSX-21 Operating Instructions - Page 9

SET UP Connections Audio Components Connections Be sure to switch power to standby and remove the power cord from the wall outlet when you make or change connections. Connect your audio components as shown below. Refer to "Digital Connections" on page 11 when making digital connections from your DVD or LD player. ANTENNA DIGITAL IN OPT 1 PCM/ /DTS FM UNBAL 75Ω OPT 2 DVD 5.1 CH INPUT OPT 3 SURROUND L SUBWOOFER AM LOOP ANTENNA S2 TO OUT MONITOR TV OPT DIGITAL OUT COAX R CENTER IN OUT L PCM/ /DTS DIGITAL IN R PLAY REC MD/TAPE 1 CONTROL OUT IN VIDEO OUT IN IN OUT PLAY REC CD TAPE 2 MONITOR IN IN IN OUT S2 S2 S2 S2 IN IN IN OUT IN IN IN OUT TV/ SAT DVD/ LD DVD 5.1 CH FRONT VCR 1 IN OUT S2 S2 VIDEO IN OUT IN OUT L R VCR 2 »« PLAY REC L L R R » OUTPUT L R FRONT PREOUT L R FRONT SPEAKERS R L CENTER PREOUT L SORROUND PREOUT R SUBWOOFER PREOUT CENTER SPEAKER R L SURROUND SPEAKERS A B CAUTION: SEE INSTRUCTION MANUAL ATTENTION: SEE INSTRUCTION MANUAL 6~LESS THAN 8Ω /SPEAKER 6~MOINS DE 8Ω /HAUTPARLEUR 8~16Ω / SPEAKER 8~16Ω / SPEAKER IMPEDANCE SELECTOR » « PLAY REC L L R R AC OUTLET AC 120V 60Hz MD recorder or Cassette deck CD player *The arrows indicate the direction of the audio signal. Cassette deck 7 Audio cords Use audio cords (not supplied) to connect the audio components. L Connect red plugs to R (right) and white plugs to L (left). R Be sure to insert completely. Cassette deck placement Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck which is caused by leakage flux from the transformer in the receiver. If you experience noise, move the cassette deck farther away from the receiver. OPERATION 9