Pioneer VSX-21 Operating Instructions - Page 27

SET UP • SIGNAL SELECT is fixed in the "ANALOG" position for components not assigned to one of the four digital input jacks. • Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from the digital output, set SIGNAL SELECT to "ANALOG". • This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and 48kHz), and DTS digital signal formats. With digital signal formats other than these, set SIGNAL SELECT to "ANALOG". # DSP MODE button Press repeatedly to select a DSP sound mode (HALL 1, HALL 2, JAZZ, DANCE, THEATER 1, or THEATER 2). Use these modes to produce surround sound from standard (two channel) stereo sources. $ MIDNIGHT button Press to hear effective surround sound at low volume levels. The effect is automatically adjusted according to the volume level. % Cinema Re-EQ button Switches Cinema Re-EQ on or off. Use to high frequency characteristics are reduced at the front channels (Front Left, Center, Front Right). (refer to page 33.) ^ DIGITAL NR button Switches DIGITAL NR on or off. Use to reduce noise in digital audio sources (refer to page 34.) & MASTER VOLUME After turning on the desired component, rotate to adjust the volume. * PHONES jack Connect headphones for private listening (the speakers turn off automatically). ( STATION/FREQUENCY (+/-) button STATION: Press to select the preset channel. FREQUENCY: Press to select the frequency. ) Function buttons Selects the function. Each press switches the DVD/LD input between DVD/LD and DVD 5.1 channel. _ TAPE 2 MONITOR button Switches the TAPE 2 monitor on or off (refer to page 42). + VIDEO INPUT jacks Connect a video camera, video game system, etc. to the VIDEO INPUT jacks (refer to page 10). Names of Parts and Basic Operations OPERATION 27