Pioneer VSX-53TX Owner's Manual - Page 99

Techno Tidbits and Problem-solving Symptom Setup The setup screen doesn't appear. Cause Remedy • The output jacks haven't been con- • Check all connections (see pages 16, nected properly. 17, 20 and 22). • The TV hasn't been connected to the • Connect the TV to the MONITOR OUT MONITOR OUT jack. jacks (see page 16). • You connected your TV to the MULTI- ROOM & SOURCE MONITOR OUT jack instead of the main MONITOR OUT jack. • Some TVs connected to the receiver with • Turn the color burst to off. (From the component video cords do not display Standby mode, and while holding the Setup Screen when color burst is on. down the MULTI JOG CONTROL RETURN button press the STANDBY/ ON button. Each action switches the color burst on or off.) Every time AUTO SURROUND SETUP is attempted, there is some kind of error, or the settings seem incorrect. • The room environment is not optimal for auto setup (too much ambient noise; obstacles blocking the speakers from the microphone; the monitor noise is interfering with the setup; etc.). • Make sure the room environment is in line with the guidelines for auto setup in this manual (see page 13 and Memo on page 15). The LARGE and SMALL settings for speakers after the Auto Surround Sound Setup are incorrect. • There are other frequencies in the room that are affecting the auto setup. • Check for household appliances (air conditioner, fan, etc.) that may be affecting the environment and switch them off if necessary. After the proper settings have been made, there still seems to be something wrong with the sound. • The speakers have been incorrectly connected (left and right connections are reversed). • Check all connections. Be sure match the right channel on the speaker with the right channel on the speaker terminals (see page 25). No audio No sound is output when a function is selected. • Improper connections. • Sound is muted. • The volume is turned down. • Speakers are turned off. • DIGITAL/ANALOG setting is incorrect. • MULTI CH IN mode is on. • Make sure the component/speakers are connected correctly (see pages 16, 17, 20, 22, 24 and 25). • Press MUTING on the remote control. • Adjust MASTER VOLUME. • Press SPEAKERS (A/B) to select the speakers you connected (see page 68). • Select the proper signal with the SIG- NAL SELECT button (see page 44). • Turn MULTI CH IN mode off (see page 53). No sound output from the front speakers. • The front speakers aren't connected properly. • Check all connections (see page 25). No sound output from surround or center speakers. • Speaker settings are incorrect. • The surround or center speakers aren't connected properly. • The listening mode is STEREO. • See SPEAKER SETTING on page 39 to check the speaker settings. • Check all connections (see page 25). • Choose a surround listening mode (see page 43). EXPERT 99