Pioneer VSX-54TX Owner's Manual - Page 63

Using other functions 09 Watching video and audio sources independently You can listen to a sound source and select a different video source on your TV. • While listening to a source, press RECEIVER,then VIDEO SEL to select the video source you want to watch. 1 Press RECEIVER. 2 Press DIMMER repeatedly to change the brightness of the front panel display. Tip • Switching the dimmer to lowest setting will also switch off the MCACC indicators. Switching the speaker impedance • Default setting: Speaker 8Ω You can use speakers with a nominal impedance between 6-16Ω but if you are using speakers with an impedance of less than 8Ω, you must change the impedance setting below. • With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button. Press repeatedly to cycle through the possible video sources. You can select DVD/LD, TV/SAT, VIDEO, VCR1/DVR, VCR2 or OFF (no video signal). • Selecting any input besides those listed above is the same as selecting OFF. Note • If you change the source using the MULTI CONTROL buttons (or the MULTI JOG dial on the front panel), or switch the power off, the system returns to normal playback. Dimming the display You can choose between four brightness for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds. Each time you do this, you switch between the impedance settings: • Speaker 6Ω - Use this setting if your speakers are rated lower than 8Ω (down to 6Ω). • Speaker 8Ω - Use this setting if your speakers are rated 8Ω-16Ω. 63 En