Pioneer VSX-54TX Owner's Manual - Page 89

Additional information 12 Symptom Cause Remedy When playing a disc, the 2 PRO LOGIC II or Neo:6 indicator lights on the receiver. • The input signal type is set to analog. • Set the receiver to AUTO or DIGITAL (see Selecting the input signal type on page 41). • A 2 channel soundtrack is currently playing. • This is not a malfunction. Check the disc packaging for details of the audio formats available on the disc. • The soundtrack currently playing is encoded using Dolby Surround. • This is not a malfunction. Check the disc packaging for details of the audio formats available on the disc. During playback of a Surround •The source may be Dolby Surround EX / DTS • Switch the surround back channel setting (page 42) to EX or DTS ES source on the SB ES software, but it has no flag to indicate it is SB CH ON then switch to the THX Surround EX or CH AUTO setting, the EX and ES 6.1 compatible. Standard EX listening mode (see Listening in surround indicators don't light, or the sound on page 37). signal is not properly processed. Remote control Symptom Cause Remedy Cannot be remote controlled. • The remote control batteries have worn out. • Replace the batteries (see Loading the batteries on page 7). • Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote sensor on the front panel (see Operating range of the remote control on page 8). • There is an obstacle between the receiver • Remove the obstacle or move to another place. and the remote control. • Strong light such as fluorescent light is • Avoid exposing the remote sensor on the front panel to shining onto the unit's remote control sensor. direct light. • Something is plugged into the CONTROL IN • Unplug the cable from the CONTROL IN jack and use jack. remote normally (see Operating other Pioneer components with this unit's sensor on page 60). • The IR receiver type is mismatched with the • Disconnect the IR receiver from the rear panel or set to setting. the other IR receiver type (see Multi-Room and IR receiver setup on page 74). Other components can't be operated with the system remote. • The preset code settings are wrong. • The batteries wore out and the system settings were cleared. • Input the correct preset code. • Reset the proper system settings. The SR cable is connected, but • The SR cable hasn't been connected the connected components can't properly. be operated with the remote. • Reinsert the SR cable, making sure it's connected to the right jack (see Operating other Pioneer components with this unit's sensor on page 60). • The rest of the component connections have not been made. • Make sure an analog connection has been made between the units. • The component you have hooked up is not a • This feature only works with Pioneer products. Pioneer product. • For information about using the remote control in the sub room, please contact your local Pioneer dealer or the Pioneer Customer Support division. Note • If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet and insert again to return to normal operating conditions. 89 En