Plantronics Voyager Legend CS Voyager Legend CS User Guide - Page 8
Desk phone standard, Check configuration and, make a test call - base
View all Plantronics Voyager Legend CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
NOTE If you will be using a standard desk phone set up or a desk phone with an HL10 lifter, continue below. If you will be using the desk phone with an EHS cable, refer to Desk phone plus EHS cable section in this guide. For further installation information refer to the EHS Getting Started guide that came with your EHS cable or at plantronics.com/accessories. Desk phone (standard) 1 Connect one end of the telephone interface cable to the back of the base. 2 Disconnect the handset coil cord from the desk phone and re-connect it to the telephone interface cable junction box. 3 Connect the remaining end of the telephone interface cable into the open handset port on the desk phone. USE NOTE Your desk phone handset will continue to work; it's just hooked up differently. NOTE If your phone has a built-in headset port, you should only use the headset port if you will not be using the HL10 lifter. In this configuration, you must first press both the headset button on your phone and the call control button on the headset to answer or end calls. Check configuration and make a test call 1 If your desk phone has a volume control set it to mid range. 2 Look at the bottom of your base and make sure the default settings are correct. Set your desk phone's volume also. Set the listening volume dial and the speaking volume dial to 2. Set the configuration switch to A. Set the desk phone volume to mid-range. 8