Pyle PWD250 User Guide - Page 14

output (+/-) 10A relay. Used for vehicle's with independent left and right parking light circuits; see GREEN/BLACK wire. • YELLOW WIRE - +12V Ignition input. Connect to a main ignition wire at the ignition switch harness.This wire shows +12V when the ignition is on and while cranking. The voltage must not drop when the car is starting. • GRAY WIRE - Siren output (+) 2A. Connect to the siren's red wire. Connect the siren's black wire to ground. If the siren is not installed, the GRAY wire may be connected to a relay to pulse the vehicle's horn. Alarm Programmable Feature step 8 must be set to Horn mode. See Alarm Programmable Features • YELLOW/BLACK WIRE - Auxiliary / trunk release output (-) 500mA. Connect to a relay for optional features such as trunk release, etc. • BLUE/BLACK WIRE - Negative door trigger (-). Connect to the door switch circuit wire that shows ground when the door is open. • ORANGE/GRAY WIRE - Hood trigger (-). Connect to an optional hood pin switch that shows ground when the hood is open. Starter Defeat/Anti-Grind Relay Socket See Starter Defeat Relay Wiring Diagrams for expanded wiring and programming information. • BLACK/RED and YELLOW WIRES Combined in 2-pin harness. Plug into 2-pin connector from 14-pin main harness. • BLUE WIRE - Starter defeat output to starter wire. After cutting the vehicle's starter wire, connect the BLUE wire to the side running to the starter. • BLUE/WHITE WIRE - Normally closed starter defeat input. After cutting the vehicle's starter wire, connect the BLUE/WHITE wire to the key side of the ignition wire if normally closed operation is desired (default). • BLUE/RED WIRE - Normally open starter defeat input. After cutting the vehicle's starter wire, connect the BLUE/RED wire to the key side of the ignition wire if normally open operation is desired. Alarm Programmable Feature step 10 must be set to button 2. See Alarm Programmable Features Alarm Module Connectors 4-Pin Connector: Plug-in connector for optional dual-zone sensor. See Alarm Module Wiring Diagram for pin descriptions. 2-Pin Connector: Plug-in connector for valet/override switch. Mount switch in an area easily accessible from the driver's position. 2-Pin Connector: Plug-in connector for LED. Mount LED in an area where it may be easily seen from either side of the vehicle. 4-Pin Connector: Plug-in connector for extended range receiver. 3-Pin Blue Connector: Not used. 3-Pin Black Connector: This connector links the alarm module to the optional remote start module using a 3-wire data-link harness. 2-Pin White Connector: Plug-in connector for shock sensor. OPTIONAL START MODULE WIRING 6-Pin Main Starter Harness • BLUE WIRE - Main accessory output (+). 12V output for heater and/or air conditioning system. For cars with more than one accessory wire add a relay(s) to power the extra accessory wire(s) or set dip switch #3 to ON and use the GREEN wire for second accessory. • YELLOW WIRE - Main ignition output (+). Connect to the main ignition wire that switches +12 V and does not drop out during cranking. • GREEN WIRE - Second ignition output (+). Connect to the wire that switches +12V and does not drop out during cranking. This wire may be optionally set for use as a second accessory wire or second starter wire. See Dip Switch Settings 14