Pyle PWD250 User Guide - Page 5

To activate anti-carjack protection: 1. Make sure the ignition is on and all doors are closed. 2. Press the valet switch once. If the carjack feature is triggered: • The LED will flash rapidly. • Warn Trigger will activate after 30 seconds. The parking lights will begin flashing and the siren will begin chirping. • Full Trigger will activate after 60 seconds. The siren will sound continuously and the starter defeat will turn on and remain on until the carjack feature is deactivated . To deactivate anti-carjack if not triggered: Press the valet switch for 3 seconds. • The siren will chirp 3 times. - or Turn off the ignition with all doors closed. To deactivate anti-carjack after Warn Trigger: Press the valet switch for 3 seconds. • The siren will chirp 3 times. - or Press transmitter button 2. To deactivate anti-carjack after Full Trigger: Press the valet switch for 5 seconds. - or Enter PIN if programmed for PIN mode. OPTIONAL SECURE PIN CODE The system may be programmed to override only when a 2-digit personal identification number is entered using the valet switch. PIN code override mode must be selected during installation or PIN code mode will not operate. To disarm the system with a PIN code: 1. Open door, alarm system will trigger 2. Turn ignition on 3. Press the override switch the number of times equal to the first digit of the PIN. 4. Turn ignition off, then back on. 5. Press the override switch the number of times equal to the second digit of the PIN. 6. Turn ignition off. • The system will disarm. Example: PIN=2,3 Press valet switch two times, turn ignition off then back on, and press valet switch 3 more times. CREATING A SECURE PIN CODE When first programmed for PIN code override mode, the default code is set to 1,1. To change the PIN code first program the system for PIN code operation, then follow the steps below: To change the PIN code: 1. Be sure the ignition is off and the system is disarmed. 2. Press the valet switch 4 times. 3. Turn ignition on. • The siren will chirp 4 times. 4. Press the valet switch once. • The siren will chirp once and enter 1st digit PIN programming. 5. Pick a 1st digit number from 1 to 4, and press the transmitter button equal to that number (example: number 2=button 2). • The siren will chirp a number of times equal to the button pressed. 6. Press the valet switch again. • The siren will chirp twice and enter 2nd digit PIN programming. 7. Pick a 2nd digit number from 1 to 4, and press the transmitter button equal to that number (example: number 3=button 3). • The siren will chirp a number of times equal to the button pressed. 8. Turn ignition off. NOTE: Record the new PIN. Once the PIN code mode is entered the standard Emergency Override will not disarm the system. 5