Pyle PWD250 User Guide - Page 7

To resume driver control: 1. Unlock the doors by pressing transmitter button 2. 2. Turn on the ignition. • The vehicle resumes driver control, when the brake pedal is pressed. AUTO COLD START This feature allows the system to start and run the vehicle every 1, 2, 4, or 12 hours (selectable by your installer) in a 24 hour period.This allows the engine to remain at an operational temperature in extremely cold weather. Auto Cold Start interval timing must be chosen during installation. Engaging the Auto Cold Start feature: To turn Auto Cold Start on: 1. Press and hold the brake pedal. 2. Press and hold button 2 for level shift. 3. Press button 1. 4. Release the brake pedal. • The vehicle will start and run the first interval to confirm cold start activation. NOTE: Press and hold button 2 for level shift then press button 2 again to shut down remote start before first run cycle is completed. The Auto Cold Start feature will remain engaged and start at the pre-programmed intervals until deactivated. Disengaging the Auto Cold Start feature: The Auto Cold Start feature can be deactivated by pressing the brake pedal. MANUAL TRANSMISSION MODE Manual Transmission Mode. Selects between Speed and Safe operating modes. On manual transmission vehicles, the remote start feature will not operate unless the proper vehicle exit sequence is performed. These two operating modes protect against in-gear starting but are not completely without risk. Installation and safe use of the remote start feature on a manual transmission vehicle is at the sole risk of the vehicle's owner, and the manufacturer assumes no liability for installation in manual transmission vehicles. Manual Transmission Quick Set Mode Exit Sequence: Turn the ignition off and the engine will remain running. Exit the vehicle. When all doors are closed, press lock button to turn off engine and arm/lock doors. The system will be able to remote start as long as the alarm is not disarmed prior to remote starting. Manual Transmission Safe Mode Exit Sequence: With ignition on, press lock button for two seconds (button mode shifts to level 2) the press lock button again. Turn ignition off (engine will stay running) and exit vehicle. When all doors are closed, press lock button to turn off engine and arm/lock doors. The system will be able to remote start as long as the alarm is not disarmed prior to remote starting. SAFETY FEATURES The System will not start the vehicle if the brake pedal is pressed or the hood is open. Also, if the brake is pressed or the hood is opened while remote running, the remote start will shut down. 7