Samsung CLX 6210FX User Manual (ENGLISH) - Page 25
Getting started, Setting up the hardware, Printing a demo Setting up the network, Supported - toners
UPC - 635753721072
View all Samsung CLX 6210FX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
getting started This chapter gives you step-by-step instructions for setting up the machine. This chapter includes: • Setting up the hardware • Printing a demo page • Setting up the network • System requirements • Installing the software • Machine's basic settings SETTING UP THE HARDWARE This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps. 1. Select a stable location. Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays. The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table. Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See "Altitude adjustment" on page 28 for more information. Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch). Otherwise, printing quality may be affected. 2. Unpack the machine and check all the enclosed items. 3. Remove the tape holding the machine tightly. 4. Install the toner cartridge. 5. Load paper. (See "Loading paper" on page 36.) 6. Make sure that all the cables are connected to the machine. 7. Turn the machine on. When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality. PRINTING A DEMO PAGE Print a demo page to make sure that the machine is operating correctly. To print a demo page: In ready mode, press and hold the OK button for about 2 seconds. SETTING UP THE NETWORK You need to set up the network protocols on the machine to use it as your network printer. You can set up the basic network settings through the machine's control panel. Supported operating environments The following table shows the network environments supported by the machine: ITEM Network interface REQUIREMENTS • Ethernet 10/100 Base-TX • IEEE 802.11 b/g Wireless LAN (optional) Network operating system • Windows 2000/XP/2003/Vista • Various Linux OS • Mac OS X 10.3 ~ 10.5 Network protocols • TCP/IP on Windows • IPP • SNMP • DHCP • BOOTP If you want to set up DHCP network protocol, go to http:// developer.apple.com/networking/bonjour/download/, select the Bonjour program that is appropriate for your computer operating system and install the program. This program will allow you to set network parameters automatically. Follow the instructions in the installation window. This program does not support Linux. Getting started_ 25