Samsung HPN5039 Owners Instructions - Page 17

Memorizing the Channels Your PDP can memorize and store all of the available channels for both "off-air" (antenna) and cable channels. After the available channels are memorized, use the CH and CH buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual). Selecting the Video Signal-source Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the PDP (i.e., an antenna or a cable system). 1 Press the MENU button. Press the UP or DOWN button to select "Channel", then press the ENTER button. Ant/ CATV Auto Program Fine Tune LNA Ch. Scan Channel Ant 0 Off Move Select Menu 2 Press the LEFT or RIGHT button to select "Ant", "STD", "HRC" or "IRC". • If you are connected to an antenna, leave "Ant" displayed. If you connected cable, press the LEFT or RIGHT button to the display the type of cable system: "STD", "HRC", or "IRC". (If you are not sure which type of cable system you have, contact your cable company). 3 Press the MENU button to exit. Ant/ CATV Auto Program Fine Tune LNA Ch. Scan Channel STD 0 Off Move Select Menu Note • STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected. Proceed to "Storing Channels in Memory" (next page). 32 Storing Channels in Memory (Automatic Method) 1 First, select the correct signal source (Ant, STD, HRC, IRC). See steps on previous page. Press the MENU button. Press the UP or DOWN button to select "Channel", then press the ENTER button. ➤ Quick way to access the Automatic Channel Setting : Just press the "AUTO PROG." button on the remote control. 2 Press the UP or DOWN button to select "Auto Program", then press the ENTER button. 3 The PDP will begin memorizing all of the available channels. After all the available channels are stored, the Auto program menu reappears. Press the RIGHT button to stop. Ant/ CATV Auto Program Fine Tune LNA Ch. Scan Channel Ant 0 Off Move Select Menu Ant / CATV Auto Program Fine Tune LNA Ch. Scan Channel Ant 0 Off Move Enter Menu Ant 50 Auto Program : Stop Note • The PDP automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes. 33